Saskatchewan Scissor Lift Certification

Saskatchewan Scissor Lift Certification - Scissor lift platforms are made use of at work locations in order to allow tradespeople - like masons, iron workers and welders - to reach their work. Making use of a scissor lift platform is usually secondary to their trade. Thus, it is vital that all platform operators be trained correctly and licensed. Lift manufacturers, regulators and industry all work together to ensure that operators are trained in the safe utilization of work platforms.

Work platforms are also known as manlifts or AWPs. These machines are stable and simple to operate, though there is always some danger since they raise individuals to heights. The following are some key safety issues common to AWPs:

To protect those working around work platforms from accidental discharge of power because of close working proximities to wires and power lines, there is a minimum safe approach distance (likewise referred to as MSAD). Voltage can arc across the air and cause injury to workers on a work platform if MSAD is not observed.

Caution should be taken when lowering a work platform to guarantee steadiness. The boom must be retracted, if you move the load toward the turntable. This would help maintain steadiness if the -platform is lowered.

The regulations about tie offs do not mandate those working on a scissor lift to tie themselves off. Some groups will on the other hand, need their staff to tie off in their employer guidelines, job-specific risk assessments or local regulations. The manufacturer-provided anchorage is the only safe anchorage to which lanyard and harness combinations must be connected.

Observe the maximum slope rating and do not go beyond it. A grade could be measured by laying a board or straight edge on the slope. A carpenter's level could then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, the per cent slope can be determined.

To be able to determine whether the unit is mechanically safe, a typical walk-around inspection must be performed. Work site assessments are likewise necessary to make sure that the work area is safe. This is important specially on changing construction sites due to the risk of obstacles, contact with power lines and unimproved surfaces. A function test should be performed. If the unit is used correctly and safely and right shutdown procedures are followed, the chances of incident are really reduced.

Click to Download the pdf